Wirecast compatibility

finalcutmtl · Joined: 04 Jul 2005 Posts: 9

I'm here trying to run Wirecast 4.1.3 on a Mac Mini (10.7.2) with a MXO2 mini with MAX. I'm struggling to find the right driver. I tried 2.5 and it won't cut it. I got tons on lag in Wirecast.

Also, I have a FCPX partition. Is there a FCPX driver that includes Compressor preset?

Thanks

Matrox_Support_Joe · Site Admin Joined: 04 Jul 2005 Posts: 2583

For wirecast, please be sure to follow the complete steps listed on page 99 of the user guide: http://www.matrox.com/video/media/pdf/support/mxo2/doc/en_Matrox_MXO2_Installation_and_User_Guide_2_5.pdf

For FCP X, the driver is available here: http://forum.matrox.com/mxo/viewtopic.php?t=7990

Note that it does support Compressor (only with MAX-enabled MXO2 units; not with the CompressHD card).

Please note that the FCP X driver supports only FCP X. Therefore, you will need a dual boot setup if you also with to use the supported software in the 2.5.0 driver.
_________________
Regards,
Joe
Matrox Video Technical Support