Matrox MXO User Forum Forum Index

 
 FAQFAQ   SearchSearch         RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Auto signal detection

 
Post new topic   Reply to topic    Matrox MXO User Forum Forum Index -> Product Feature Enhancements
View previous topic :: View next topic  
Author Message
marc.colemont
(MXO2)




Joined: 04 Jul 2005
Posts: 46

PostPosted: Thu Nov 05, 2009 11:43 am    Post subject: Auto signal detection Reply with quote

It is sometimes very hard (only by starting up FCP and recording mode) to see if there is a valid signal.
If there was an indication in the 'Systems Preference' Menu of the 'Matrox MXO2' which shows which input has signal, and which resolution and framerate would make it more professional.
Back to top
View user's profile Send private message
Andy Mees
(MXO)




Joined: 04 Jul 2005
Posts: 1016

PostPosted: Fri Nov 06, 2009 7:51 am    Post subject: Reply with quote

Agreed. MXO2 Preference Pane needs a "Preview" tab under which one can preview the incoming Audio and Video (according to the selected A/V Input >> Input Source) together with a display of technical information pertaining to the incoming video eg frame size, frame rate and audio levels.

Best
Andy
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Matrox MXO User Forum Forum Index -> Product Feature Enhancements All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

This board is protected by Phpbbantispam
Powered by phpBB © 2001, 2002 phpBB Group